A box
Free UK Mainland Delivery on online order over £500*
An award
Over 40 Years of industry experience
Warehouse
Extensive Warehouse stocking over 10,000 products

Please refresh the page in 1 minute to see the next delivery time.

Our next despatch cut-off point is ?? Days ?? Hours ?? Minutes ?? Seconds

ST166 INJECTOR-1.3mm

ST166 INJECTOR-1.3mm

SKU

Description

The Suttner ST166 injector is used for mixing two chemicals together. These injectors are available with nozzle sizes 1.3mm, 1.6mm and 1.9mm. To find all the required products for your injector please use our interactive chart, you just need to know the flow and pressure of the machine you will be using the injector on.

Technical Spec

Inlet3/8" Female
Outlet3/8" Male
MaterialStainless Steel
Bar350
Max Temp °C90
Nozzle Size1.3mm
DN Internal Diameter9mm
Weight0.40
Country of OriginGermany

Datasheets

Need help?

Contact G&S 01768 865985

Overview

EASYFOAM365+, ST166 INJECTOR 3/8"F X 3/8"M 2 hose tails @ 9 mm. Injector for applications with chemicals and foam. The injector sucks in/admixes up to two chemicals at the same time. The chemical dosing is adjusted by 2 x 10 exchangeable nozzle inserts (0.5 - 2.0 mm). Max. 350 bar / 90 °C

Help with sizes

Use the below chart to help you select the correct injector size.

Using the chart

You will need to know the flow rate and pressure of the pressure washer or system that the injector is to be installed.

Firstly select the closest flow rate (round up if required)

Then move right across the chart until you are at the closest pressure column.

The top number (1.6) is the injector size.

The number in brackets underneath is the recommended ST75 foam lance required.

Distributor request Don't have a G&S account but need a distributor? Click Here