A box
Free UK Mainland Delivery on online order over £500*
An award
Over 40 Years of industry experience
Warehouse
Extensive Warehouse stocking over 10,000 products

Please refresh the page in 1 minute to see the next delivery time.

Our next despatch cut-off point is ?? Days ?? Hours ?? Minutes ?? Seconds

HYGIENE ULTRA 20M RED 1/2"M/F

HYGIENE ULTRA 20M RED 1/2"M/F

SKU

Description

This is Hygiene Ultra 40 hose, suitable for contact with liquid food products featuring an antimicrobial top layer. The antimicrobial properties of this hose will stop the growth of micro-organisms, dramatically lowering the risk of cross contamination. This hose has a diameter of DN12 which makes it a good choice for anyone using a compressed air connection on their foam injector.

Technical Spec

Inlet1/2" Male BSPT
Outlet1/2" Female
Bar40
ColourRed
Length20m
Max Temp °C70
DN Internal Diameter12mm
Weight4.95
Country of OriginUnited Kingdom

Datasheets

Need help?

Contact G&S 01768 865985

Overview

Open plant cleaning using foam

Open plant cleaning enures all machines and surfaces in a food processing environment are thoroughly cleaned and disinfected. As a producer or processor of foods it is critical to maintain constant hygiene standards. This is done by applying a clingy foam using specialist equipment such as a foam injector and foam lance. Due to it's internal 12mm diameter our Hygiene Ultra 40 hose is ideal for a system that generates foam using a compressed air module at the injector. This diamteter enables the foam to travel down the hose without collapsing back into a liquid state, the foam exits via a specialist foam lance or wash gun. Another major benefit of using our exclusive Hygiene Ultra 40 hose as part of a cleaning system is it's antimicrobial top layer. The properties of this layer will stop the growth of micro-organisms, dramatically  lowering the risk of cross contamination.

G&S have a range of equipment dedicated to cleaning food processing environments. Take a look at our Food Industry page for more information.

Hygiene Catalogue request

* indicates required

Help with sizes

Use the below chart to help you select the correct injector size.

Using the chart

You will need to know the flow rate and pressure of the pressure washer or system that the injector is to be installed.

Firstly select the closest flow rate (round up if required)

Then move right across the chart until you are at the closest pressure column.

The top number (1.6) is the injector size.

The number in brackets underneath is the recommended ST75 foam lance required.

Distributor request Don't have a G&S account but need a distributor? Click Here